Открытый доступ Открытый доступ  Ограниченный доступ Доступ для подписчиков

Влияние старения и массовой доли Al2O3 на механические свойства композита Al6O82/Al2O3, полученного литьем с перемешиванием

Н. Сираджудин, М. Абдур Рахман

Аннотация


Исследовано влияние искусственного старения на механические свойства сплава Al6O82 и композита Al6O82/(2 - 10 %)Al2O3, полученных литьем с перемешиванием (stir casting). Исследована структура с помощью сканирующего электронного микроскопа с полевой эмиссией, измерены кривые растяжения, работа удара и твердость. Показано, что увеличение доли упрочняющей фазы и искусственное старение (180 °C, 2 ч) приводят к повышению прочности на растяжение, твердости и вязкости, а также к равномерному распределению частиц Al2O3 в матрице.

Ключевые слова


литье с перемешиванием; дисперсионное твердение; композит Al6O82/Al2O3; механические свойства; микроструктура; stir casting; precipitation hardening; Al6O82/Al2O3 composite; mechanical properties; microstructure

Полный текст:

PDF

Литература


Rahimian M., Ehsania N., Parvin N., Baharvandi H. R. The effect of particle size, sintering temperature and sintering time on the properties of Al - Al2O3 composites, made by powder metallurgy // J. Mater. Process Technol. 2009. V. 209. P. 5387 - 5393.

Sharifi E. M., Karimzadeh F., Enayati M. H. Fabrication and evaluation of mechanical and tribological properties of boron carbide reinforced aluminum matrix nanocomposites // Mater. Des. 2011. V. 32. P. 3263 - 3271.

Hemanth J. Quartz (SiO2p) reinforced chilled metal matrix composite (CMMC) for automotive applications // Mater. Des. 2009. P. 30323 - 30329.

Ezatpour Hamid Reza, Sajjadi Seyed Abolkarim, Sabzevar Mohsen Haddad, Huang Yizhong. Investigation of microstructure and mechanical properties of Al6061-nanocomposite fabricated by stir casting // Mater. Des. 2014. V. 55. P. 921 - 928.

Ravi K. R., Sreekumar V. M., Pillai R. M. et al. Optimization of mixing parameters through a water model for metal matrix composites synthesis // Mater. Des. 2007. V. 28. P. 871 - 881.

Xu Z. M., Loh N. L., Zhou W. Hot isostatic pressing of SiCp-reinforced aluminium-based composites // J. Mater Process Technol. 1997. V. 67, No. 1 - 3. P. 131 - 136.

Hamed Osama A., Shady M. A., El-Desouky A. R. Creep behaviour of a cast 359/SiC/10p aluminium composite // Int. J. of Materials and Design. 2001. V. 22. P. 473 - 479.

Kok M. Production and mechanical properties of Al2O3 particle-reinforced 2024 aluminium alloy composites // J. Mater Process Technol. 2005. V. 161. P. 381 - 387.

Su H., Gao W., Feng Z., Lu Z. Processing, microstructure and tensile properties of nano-sized Al2O3 particle reinforced aluminum matrix composites // J. Mater. Des. 2012. V. 36. P. 590 - 596.

Lai J., Zhang Z., Chen X. G. Precipitation strengthening of Al-B4C metal matrix composites alloyed with Sc and Zr // J. Alloys Compd. 2013. V. 552. P. 227 - 235.

Zhang Q., Ma X., Wu G. Interfacial microstructure of SiCp /Al composite produced by the pressureless infiltration technique // J. Ceram. Int. 2013. V. 39. P. 4893 - 4897.

Kainer K. U. Metal matrix composites: custom-made materials for automotive and aerospace engineering. Basics of metal matrix composites. WILEY-VCH Verlag GmbH & Co. KGaA; [chapter 1]. 2006. P. 1 - 54.

Toptan Fatih, Kilicarslan Ayfer, Karaasla Ahmet et al. Processing and microstructural characterisation of AA1070 and AA6063 matrix B4Cp reinforced composites // Mater. Des. 2010. V. 31. P. 587 - 591.

Fallah V., Langelier B., Ofori-Opoku N. et al. Cluster evolution mechanisms during aging in Al - Mg - Si alloys // Acta Mater. 2016. V. 103. P. 290 - 300.

Edwards G. A., Stiller K., Dunlop G. L., Couper M. J. The precipitation sequence in Al - Mg - Si alloys // Acta Mater. 1998. V. 46. P. 3893 - 3904.

Wang X., Esmaeili S., Lloyd D. J. The sequence of precipitation in the Al - Mg - Si - Cu alloy // Metall. Mater. Trans. A. 2006. V. 37. P. 2691 - 2699.

Sokolowski J. H. Thermoelectric power characterization of a 2024 aluminum alloy during solution treatment and aging // Mater. Charact. 1996. V. 40. P. 83 - 92.

Kumar K. S., Brown S. A., Pickens J. R. Microstructural evolution during aging of an A - Cu - Li - Ag - Mg - Zr alloy // Acta Mater. 1996. V. 44, No. 5. P. 1899 - 1915.

Hirth S. M., Marshall G. J., Court S. A., Lyloyd D. J. Effects of Si on the aging behavior and formability of aluminium alloys based on AA6016 // Mater. Eng. A. 2001. V. 319. P. 452 - 456.

Bekheet N. E., Gadelrap R. M., Salah M. F. et al. The effects of aging on the hardness and fatigue behaviour of 2024 Al alloy/SiC composites // Mater. Des. 2002. V. 23. P. 153 - 159.

Park J. K., Ardell A. J. Correlation between microstructure and calorimetric behavior of aluminum alloy 7075 and Al - Zn - Mg alloys in various tempers // Mater. Sci. Eng. A. 1989. V. 114. P. 197.

Donoso E. Calorimetric study of the dissolution of Guinier- Preston zones and η' phase in Al - 4.5 at.% Zn - 1.75 at.% Mg // Mater. Sci. Eng. 1985. V. 74. P. 39.

Murtha S. J. New 6XXX aluminum alloy for automotive body sheet applications // SAE Int. J. Mater. Manuf. 1995. V. 104. P. 657 - 666.

Abis S., Boeuf A., Caciuffo R. et al. Investigation of Mg2Si precipitation in an Al - Mg - Si alloy by small angle neutron scattering // J. Nucl. Mater. 1985. V. 135. P. 181 - 189.

Marioara C. D., Nordmark H., Andersen S. J., Holmestad R. Post-b phases and theirinfluence on microstructure ad hardness in 6xxx Al - Mg - Si alloys // J. Mater. Sci. 2006. V. 41. P. 471 - 478.

Edwards G. A., Stiller K., Dunlop G. L., Couper M. J. The precipitation sequence in Al - Mg - Si alloys // Acta Mater. 1998. V. 46. P. 3893 - 3904.

Marioara C. D., Andersen S. J., Jansen J., Zandbergen H. W. The influence of temperature and storage time at RT on nucleation of the beta phase in a 6082 Al - Mg - Si alloy // Acta Mater. 2003. V. 51. P. 789 - 796.

Yassar S. R., Field P. D. Transmission electron microscopy and differential scanning calorimetry studies on the precipitation sequence in an Al - Mg - Si alloy: AA6022 // J. Mater Res. 2005. V. 20. P. 2705 - 2711.

Sharma P., Sharma S., Khanduja D. Production and some properties of Si3N4reinforced aluminium alloy composites // J. Asian Ceram. Soc. 2015. V. 3. P. 352 - 359.

Feng Y. C., Geng L., Fan G. H. et al. The properties and microstructure of hybrid composites reinforced with WO3 particles and Al18B4O33 whiskers by squeeze casting // Mater. Des. 2009. V. 30. P. 3632 - 3635.

Gao H. Q., Wang L. D., Fei W. D. Interfacial reaction and tensile strength of copper-coated Al18B4O33 whisker reinforced 6061 Al composite // J. Mater. Sci. Eng. A. 2008. V. 479. P. 261 - 268.

Rajan T. P. D., Pillai R. M., Pai B. C. Reinforcement coatings and interfaces in aluminium metal matrix composites // J. Mater Sci. 1998. V. 33. P. 3491 - 3503.

Ramesh C. S., Keshavamurthy R., Channabasappa B. H., Ahmed Abrar. Microstructure and mechanical properties of Ni - P coated Si3N4 reinforced Al6061 composites // Mater. Sci. Eng. A. 2009. V. 502. P. 99 - 106.

Tang F., Wu X., Ge S. et al. Dry sliding friction and wear properties of B4C particulate-reinforced Al-5083 matrix composites // Wear. 2008. V. 264, No. 7 - 8. P. 555 - 561.

Answarkhan A. R., Ramesh C. S., Ramachandra A. Heat treatment of Al6061-SiC composites // Proc. Inter. Conf. Manf. (ICM). 2002. P. 21 - 28.

Prabhu Swamy N. R., Ramesh C. S., Chandrashekar T. Effect of heat treatment on strength and abrasive wear behaviour of Al6061-SiCp composites // Bull. Mater. Sci. 2010. V. 33, No. 1. P. 49 - 54.

Topcua I., Gulsoy H. O., Kadioglu N., Gulluoglu A. N. Processing and mechanical properties of B4C reinforced Al matrix composites // J. Alloy Compd. 2009. V. 482. P. 516 - 521.

Sridhar Raja K. S., Bupesh Raja V. K. Effect of boron carbide particle in wear characteristic of cast aluminium A356 composite // IOSR-JMCE. 2014. P. 73 - 77.

Ramesh C. S., Keshavamurthy R., Channabasappa B. H., Abrar Ahmed. Microstructure and mechanical properties of Ni - P coated Si3N4reinforced Al6061 composites // Mater. Sci. Eng. A. 2009. V. 502. P. 99 - 106.

Prabhu Swamy N. R., Ramesh C. S., Chandrashekar T. Effect of heat treatment on strength and abrasive wear behaviour of Al6061-SiCp composites // Bul. Mater. Sci. 2010. V. 33. P. 49 - 54.





© Издательский дом «Фолиум», 1993–2021