Влияние температуры рекристаллизационного отжига на механические свойства и текстуру холоднокатаного коррозионно-стойкого Al – Mg – Ti-сплава
Аннотация
Исследована текстура холоднокатаных листов из коррозионно-стойкого Al – Mg – Ti-сплава после деформации и последующего рекристаллизационного отжига при различных температурах с использованием рентгенодифрактометрического метода обратных полюсных фигур по Моррису. Определены температурные зависимости параметров текстурного состояния и механических свойств исследованного сплава. Рентгенографическим фотометодом изучен процесс первичной рекристаллизации в сплаве и сделан вывод о пороговом значении температуры начала рекристаллизации.
Ключевые слова
Литература
Skripalenko M. M., Rogachev S. O., Skripalenko M. N. et al. Estimation of deformation zone parameters and their influence on microstructure and properties formation of aluminum strip while cold rolling // J. Mater. Eng. Perform. Published online. DOI: 10.1007/s11665-025-12920-w
Wang G., Peng C., Zhang B. et al. Effect of the annealing process on the microstructure and performance of 5056 aluminum alloy wires // Metals. 2022. V. 12, Is. 5. Art. 823.
Поспелов И. Д., Кожевников А. В., Матвеева Д. В. Влияние температуры рекристаллизационного отжига на механические свойства и структуру холоднокатаной стальной полосы // МиТОМ. 2025. № 11. С. 11 – 16.
Matvija M., Fujda M., Milkovič O. et al. Thermal stability of the ultra-fine-grained structure and mechanical properties of AlSi7MgCu0.5 alloy processed by equal channel angular pressing at room temperature // Crystals. 2025. V. 15, Is. 8. Art. 701.
Qian Х., Parson N., Chen X.-G. Effects of Mn content on recrystallization resistance of AA6082 aluminum alloys during post-deformation annealing // J. Mater. Sci. Technol. 2020. V. 52, Is. 1. P. 189 – 197.
Li Y., Qian X., Zhang Y. et al. Analysis on the hot deformation flow stress curves of novel 6082 aluminium alloys with Mn addition // IOP Conf. Ser.: Mater. Sci. Eng. V. 1133. Art. 012007.
Elasheri A., Ghosh A., Parson N., Chen X.-G. Microstructure and texture evolution during extrusion of 6xxx aluminum alloys with Mn/Zr additions // J. Mater. Sci. 2025. V. 60. P. 22252 – 22269.
Farsadhemmati S., Shaban Ghazan M., Eghbali B. Effect of post-deformation annealing on the microstructure and mechanical properties of AA6061/AA1050 laminated composite processed by accumulative roll bonding // MMA. V. 2025, Is. 14. P. 946 – 958.
Aryshenskii E., Drits A., Konovalov S. et al. Impact of the strain rate and grain size on the intensification or mitigation of the serrated flow behavior presented in commercial 5182 and 1565Ch Al – Mg alloys // J. Mater. Eng. Perform. 2025. V. 34. P. 26509 – 26519.
Algendy A. Y., Liu K., Chen X.-G. Effect of Mn-bearing dispersoids on tensile properties and recrystallization resistance of Al – 3Mg – 0.8Mn rolled alloy // Adv. Eng. Mater. 2023. V. 25, Is. 19. Art. 2300667.
Matvija M., Fujda M., Milkovič O. et al. Phase analysis of EN AW 6023 aluminum alloy after short time Aging // Manuf. Technol. 2017. V. 17, Is. 6. P. 912 – 916.
Liu F., Zhu X., Qin J. et al. Effect of Mn / Cr ratio on precipitation behaviors of -Al(FeMnCr)Si dispersoids and mechanical properties of Al – Mg – Si – Cu alloys // Mater. Sci. Eng. A. 2022. V. 860, Is. 1. Art. 144269.
Šlapáková М., Kihoulou B., Grydin O. Development of microstructure of asymmetrically rolled AA3003 aluminium sheets with Zr addition // JALMES. 2023. V. 2, Is. 2. Art. 100012.
Bakr A., Rometsch P., Chen X.-G. Effect of Sc and Zr microalloying on recrystallization behavior of 1xxx aluminum heat exchanger alloys during post-deformation annealing // J. Mater. Sci.: Mater. Eng. 2025. V. 20. Art. 84.
Riddle Y. W., Sanders T. H. Recrystallization performance of AA7050 varied with Sc and Zr // Mater. Sci. Forum. 2000. V. 331 – 337. P. 799 – 804.
Forbord B., Hallem H., Marthinsen K. The effect of Sc on the extrudability and recrystallisation resistance of Al – Mn – Zr-alloys // Mater. Sci. Forum. 2004. V. 467 – 470. P. 369 – 374.
Бецофен С. Я., Ашмарин А. А., Ву Р. и др. Исследование распределения текстуры интерметаллидных фаз d и Т1 по сечению листов сплавов системы Al – Cu – Li // Деформация и разрушение материалов. 2025. № 11. С. 10 – 19.
Бородкина М. М., Спектор Э. Н. Рентгенографический анализ текстуры металлов и сплавов. М.: Металлургия, 1981. 272 с.
Huang J., Tornheim A. P., Shi X. et al. Dispersive x-ray absorption spectroscopy using independent grazing-incidence focusing and convexly bent Bragg-crystal dispersing optics // J. Synchrotron Radiat. 2025. V. 32, Is. 4. P. 1068 – 1084.
Горелик С. С., Скаков Ю. А., Расторгуев Л. Н. Рентгенографический и электронно-оптический анализ. М.: МИСиС, 1994. 328 с.
Hirsch J. R., Lücke K. Description and presentation methods for textures // Textures and Microstuctures. 1988. Vol. 8 – 9. P. 131 – 151.
DOI: https://doi.org/10.30906/mitom.2026.5.13-17
© Издательский дом «Фолиум», 1998–2026
